Page: Posts
Unit weight of materials used in Construction 50+
Unit weight of materials used in Construction The unit weight of materials is an important factor to consider in engineering and construction projects. It refers to the weight of a material per unit volume, typically
For the smooth vertical wall shown in Figure Q1, determin…Solved.
Question For the smooth vertical wall shown in Figure Q1, determine the total active thrust on the wall and the position where it acts. Ground water level is at a depth of 1.5 m. Solution
A 10 m high retaining wall has been holding a soil with the…Solved.
Question A 10 m high retaining wall has been holding a soil with the following composition: G=2.65, e= 0.50, w=10%, and Ф=20 degrees. Determine the active thrust on the wall due to soil and water,
For the smooth vertical wall shown in figure Q3. Determin…Solved.
Question For the smooth vertical wall shown in figure below. Determine the total active thrust on the wall and the position where it acts. ground water level is at a depth of 1.5m Solution
Solved: A six story reinforced concrete framed office building for …
Question 1 – A six story reinforced concrete framed office building for the Education Service Commission will be built on a proposed site at Kyambogo Kampala where the soils are expected to be of average
A foundation 4×2 m2 carrying a uniform pressure of (Solved)
Question A foundation 4×2 m2 carrying a uniform pressure of (q-OzD) = • 150 kN/m2 is located at a depth of 1 m in a layer of clay 5 m thick, for which E =
A foundation 4m x 2m, carrying a uniform pressure of 150(Solved: )…
Question A foundation 4m x 2m, carrying a uniform pressure of 150kPa, is located at a depth of 1m in a layer of clay 5m thick for which the value of Es is 40MPa. The
A foundation 4m x 42m carries a uniform pressure of 200…Solved:
Question A foundation 4m x 42m carries a uniform pressure of 200kPa at a depth of 1m in a layer of saturated clay 11m deep and underlain by a hard stratum. If undrained elastic modulus,